Accessories

View as Grid List
Sort by
Display per page

TiePie Back Probe Set

TiePie Engineering thin and flexible back probes. These back probes can be used on most measuring leads with non insulated 4 mm banana plugs. The long, thin and flexible tip makes it possible to connect to hard to reach places. The Back Probe TP-BP85 - Set comes in a set containing 8 back probes, four black ones, a red one, a yellow one, a green one and a blue one.
£46.80 incl tax

TiePie Rubber Protector

The TiePie rubber protector can be used on the Handyscope HS3, Handyscope HS4, Handyscope HS4 DIFF, Handyscope HS5, Handyscope HS6 DIFF and Automotive scope. The Rubber protector is available in red, black and yellow.
£23.99 incl tax

Current clamp TP-CC400

The Current clamp TP-CC400 is a current clamp that will allow your oscilloscope to measure electrical currents up to 400 A AC/DC. When measuring with this current clamp, there is no need to break a closed circuit or to affect the isolation.

The wide jaws allow performing measurements on thick conductors.

For measuring DC current, a simple to operate zero adjust button is available.
£100.80 incl tax

Current clamp TP-CC600

The Current clamp TP-CC600 is a current clamp that will allow your oscilloscope to measure electrical currents up to 600 A AC/DC, with a frequency response up to 400 Hz. When measuring with this current clamp, there is no need to break a closed circuit or to affect the isolation.

The wide jaws allow performing measurements on thick conductors.

For measuring DC current, a simple to operate zero adjust button is available.
£91.20 incl tax

Current clamp TP-CC80

The Current clamp TP-CC80 is a current clamp that will allow your oscilloscope to measure electrical currents up to 80 A AC/DC, with a frequency response up to 20 kHz. When measuring with this current clamp, there is no need to break a closed circuit or to affect the isolation.

The long, narrow jaws allow performing measurements in narrow spaces.

For measuring DC current, a simple to operate zero adjust button is available.
£103.20 incl tax

Differential attenuator TP-DA25

The Differential attenuator TP-DA25 is a differential 1:25 attenuator, combined with a low noise differential measure lead. It is specially designed to be used with the Automotive scope ATS610004D-XMSG or Automotive scope ATS5004D, to measure high voltages like e.g. in electrical and hybrid vehicles.
£145.20 incl tax